Keeping Your Poultry Heaters Alive in a Messy Coop
Let’s be honest: chicken coops are brutal. Between the ammonia fumes, the constant humidity, and the inevitable water splashes from the drinkers, it’s basically a death trap for standard infrared lamps. Most of them just can’t take the abuse and burn out way too fast. That’s exactly why we built our waterproof heaters. We wanted something that could actually survive the grime without quitting on you. Dealing with the wet stuff Here is the problem with standard quartz tubes: if a stray drop of water hits that scorching hot glass, it shocks the material. The result? A crack. Just like that, your heater is trash. To stop that from happening, we wrapped everything in a splash-proof housing and put tight seals on all the connection points. No leaks, no liquid getting where it shouldn’t. We also added an anti-fog design. It keeps the emitter surface clear so heat doesn’t get trapped inside the cover, which is usually what kills the heating element over time. Built to last (really) We didn’t just stop at the housing. We used reinforced quartz glass and special coatings to keep the ammonia from eating away at the tubes. The seals are the unsung heroes here. They’re rated for high heat, so they won’t melt or warp after a few weeks of work. And because we sealed the electrical terminals, you don’t have to worry about the damp air causing oxidation or a short circuit. It just works. What you need to know for installation If you already have a heating setup, these are easy. They’re basically drop-in replacements. You can get them wired up in no time. But, there is a small trade-off. Because the waterproof housing adds a bit of insulation, it takes a little longer for the heat to hit full blast compared to a bare bulb. A couple of pro tips: First, get your mounting height right. You want the birds to be warm, but you don’t want the housing trapping too much heat against your ceiling. Second, keep an eye on the dust. If you mount these too close to the bedding, dust will build up on the shield and block the heat. Every now and then, just give the exterior a quick wipe. It keeps the heat flowing and your birds happy.