Stop wasting time on burnt-out lamps in your SIG Blomax lines
If you’re running SIG Blomax lines, you know the frustration. You’re in the middle of a run and—pop—another tube goes. It’s annoying. Usually, it’s just the result of the machine shaking or the constant heating and cooling wearing the glass down. To fix this, we built a reinforced replacement lamp specifically for Nissei ASB systems. The deal with heat and stress These are simple drop-in replacements. We kept the wattage and voltage exactly where they need to be so your oven doesn’t act up. Here’s the thing: when you crank up the heat to shave seconds off your cycle time, that quartz envelope takes a beating. That’s why we went with a heavier wall thickness. It handles the vibrations of a high-speed blowing machine way better than the standard stuff. Built to actually last Most lamps give up the ghost at the pinch seal or the connector. It’s a weak point. We beefed up the ends of the tube so they don’t snap during installation or while the machine is humming along. We also tweaked the quartz purity. You still get the infrared transmission you need, but the tube can handle the “thermal shock” of rapid on-off cycles without cracking. It just feels sturdier. Getting them running You can wire these straight into your current SIG setup. No fuss. One quick heads-up: because the quartz is thicker, there’s a bit more thermal mass. Your techs might need to nudge the PID settings on the temperature controller to get the timing just right. And a pro tip? Check your cooling fans. If they’re clogged with dust, no lamp—no matter how reinforced—is going to survive the overheat. Keep the air moving, and these tubes will last you a long time.